Post bug reports at http://sourceforge.net/projects/equ
Last modified : 31/August/2002

- The preamp sliders don't really cause a preamp of the sound but rather a 
  volume control at the output of the EQ.. which is more a POSTamp :)
- If the EQ plugin was not being used and you decide to use it by going to the
  configure menu, you will not see the GUI until you restart XMMS
  (I haven't looked too much into this, but there seems to be no way
  of making the GUI to show after the OK/Apply button is selected unless
  a patch to the XMMS core is made to let the effect plugins know when they
  are being activated, like the enable_general_plugin function)
- In some cases you will hear artifacts in the output. This is due to
  excesive amplification of the signal. Try to adjust the gain of the bands
  and also normalize the piece of audio you're listening to.
- The volume level of the non-affected bands (i.e. those at ZERO) is below
  the volume level of the original sound.
- Only supports 16bit signed PCM
- The presets and all that in the Presets menu have not been tested
  (AFAIK the Auto option is not working)
- Auto Load of presets is not working because XMMS doesn't notify the Effect
  plugins when there's a file change nor the filename (these are required
  in order to support Auto Load of presets)
- EQ is not activated when used inside Crossfade 0.2.9
- The values of the bands are not saved separately based on the number of bands
  i.e. if you were using 31 bands and then recompile and use 15 you will notice
  that the values of the 15 bands are the same as those in the lower 15 bands
  of the 31 band version.
